Chapter 4.3 Access Points
85
4.3.3 Adding
The administrator can add supported APs into the
List
table manually here. Enter the related information of the AP
and select a
Template Applied
. Click
ADD
and then the AP will be added to the
List
. Similar to the AP added after
discovery, a manually added AP will show up with a status of “configuring” in the AP List initially. The system will
attempt to configure the AP with the value specified. A couple of minutes later, the AP’s status will become “online” or
“offline” on the AP List.
y
AP Type:
The type of supported AP.
y
AP Name:
The mnemonic name of the specific AP.
y
Admin Password:
The password of the AP for the system to access it.
y
IP Address:
The IP address of the AP.
y
MAC Address:
The Media Access Control (MAC) address of the AP.
y
Remark:
The administrator can add some extra information for the AP in this field if desired.
y
Service Zone:
When the system’s Service Zone is set to Tag-based mode, additional Service Zone field will be
here for assigning services zones to the AP.
y
Template Applied:
The template which will be applied to the AP.
y
Channel:
The Channel of the AP.
Summary of Contents for DSA-3600
