D-Link DSA-3600, User Manual

Page: 88 / 204

Chapter 4. Web Interface Configuration
82
4.3.2 Discovery
Use this function to detect and manage all the supported APs in the network segment.
y
Discovery Settings
When the administrator tries to discover a new AP, select the AP Type and select the Interface (Service Zone)
first. If the system is set to Tag-Base mode, only Default Service Zone is available for AP Discovery. Second,
select
Manual
in
Admin Settings Used to Discover
field. If the AP is reset to default setting, please select
Factory Default, enter the current IP range of the APs, Login ID and Password. The IP of AP with factory default
setting is “192.168.0.50”. Then click
Scan Now
button. If the new AP has been discovered, it will appear in the
following Discovery Results list. If there is a warning message showing below the Discovery Settings, follow the
instructions to change configurations.
Note: Please refer to the datasheet for the supported APs (and the firmware version as well as the hardware
version).
Please fill in the required data.
¾
Interface
: Select the default service zone of the interface where APs are connected and to be scanned.
¾
Admin Settings Used to Discover:
Select Manual, enter the current IP range of the APs in IP Address
field if they are not in default value. The IP of AP with factory default setting is "192.168.0.50". If the AP
was discovered before, the IP address of the AP should have been changed. Please enter the right IP
address of the AP or reset the AP to default values. Login ID is the admin ID of the AP. Password is the
admin password of the AP. If the AP is in default value, just select Factory Default, system can discovery