D-Link DSA-3600, User Manual

Page: 89 / 204

Chapter 4.3 Access Points
83
the APs.
¾
IP Addresses of APs after Discovery
: It is the start IP address that will be assigned to the discovered
APs and it must be in the same segment of the selected ALN interface (Service Zone).
¾
Scan Now:
Click the
Scan Now
button and the APs that match the given settings will be shown in the
Discovered Results below. If any IP address among the IP range assigned for a specific AP is used, there
will be a warning message showing up. Please change the
IP Addresses of APs after Discovery
and
then click Scan Now again. For the desired AP, input the desired AP name and admin password, select
one template to apply, select the check box, and click
Add
to add the discovered AP to the List. For more
information about the template, please refer to
4.3.4 Templates
.
y
Background AP Discovery
The system supports discovering APs periodically in background. The New IP Address Assignment and Access
to the AP Admin Interface configuration in Background Auto Discovery page are the same as in the Discovery
Settings. Click
Configure
and then select
Enable
to set the configuration. When
Auto Adding AP to the list
is
enabled, the system will add the discovered APs into the List table automatically and apply the selected
template in the Template Applied option to the AP. When the configurations are set as requirement, the system
will discover new APs periodically and automatically in background.
Click
Configure
to enter the
Background AP Discovery
page to have further configuration.