D-Link DAS-3636, Cli Reference Manual

Page: 7 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Setting the Switch’s IP Address
Each Switch must be assigned its own IP Address, which is used for communication with an SNMP network manager or other
TCP/IP application (for example BOOTP, TFTP). The Switch’s default IP address is 10.90.90.90. Users can change the default
Switch IP address to meet the specification of your networking address scheme.
The Switch is also assigned a unique MAC address by the factory. This MAC address cannot be changed, and can be found on the
initial boot console screen – shown below.
boot Procedure V1.03.B016
-------------------------------------------------------------------------------
Power On Self Test ........................................ 100%
MAC Address : 00-26-54-60-54-60
H/W Version :
Please Wait, Loading V1.02.B018 Runtime Image [1] ......... 100%
R2R3R4R5R6
BME 1:POST: Success
BME 2:POST: Success
BME 3:POST: Success
BME 1:Download: Downloaded successfully
BME 2:Download: Downloaded successfully
BME 3:Download: Downloaded successfully
VDSL driver version 5.3.0.13IK005010
UART init ................................................. 100 %
Figure 1-2. Boot screen
The Switch’s MAC address can also be found in the Web management program on the Switch Information (Basic Settings)
window on the Configuration menu.
The IP address for the Switch must be set before it can be managed with the Web-based manager. The Switch IP address can be
automatically set using BOOTP or DHCP protocols, in which case the actual address assigned to the Switch must be known.
The IP address may be set using the Command Line Interface (CLI) over the console serial port as follows:
1. Starting at the command line prompt, enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy . Where the x ’s represent the IP address to be assigned to the IP interface named
System and the y ’s represent the corresponding subnet mask.
2. Alternatively, users can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z . Where the x ’s represent the IP address to
be assigned to the IP interface named System and the z represents the corresponding number of subnets in CIDR
notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask which can then be used to connect a
management station to the Switch’s Telnet or Web-based management agent.
DAS-3626:admin#config ipif System ipaddress 10.24.73.21/8
Command: config ipif System ipaddress 10.24.73.21/8
Success.
DAS-3626:admin#
Figure 1-3. Assigning an IP Address screen
In the above example, the Switch was assigned an IP address of 10.24.73.21 with a subnet mask of 255.0.0.0. The system message
Success indicates that the command was executed successfully. The Switch can now be configured and managed via Telnet,
SNMP MIB browser and the CLI or via the Web-based management agent using the above IP address to connect to the Switch.
2