D-Link DAS-3636, Cli Reference Manual

Page: 160 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
19
L
INK
A
GGREGATION
C
OMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create link_aggregation group_id <value 1-6> {type [lacp | static]}
delete link_aggregation group_id <value 1-6>
config link_aggregation group_id <value 1-6> {master_port <port> | ports <portlist> | state [enable | disable]}
config link_aggregation
algorithm [mac_source | mac_destination | mac_source_dest | ip_source | ip_destination |
ip_source_dest]
show link_aggregation {group_id <value 1-6> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose Used to create a link aggregation group on the Switch.
Syntax create link_aggregation group_id <value 1-6> {type[lacp | static]}
Description This command will create a link aggregation group with a unique identifier.
Parameters
<value>
−
Specifies the group ID. The Switch allows up to six link aggregation groups to be
configured. The group number identifies each of the groups.
type – Specify the type of link aggregation used for the group. If the type is not specified the
default type is static .
•
lacp – This designates the port group as LACP compliant. LACP allows dynamic
adjustment to the aggregated port group. LACP compliant ports may be further
configured (see config lacp_ports). LACP compliant must be connected to LACP
compliant devices.
•
static – This designates the aggregated port group as static. Static port groups can
not be changed as easily as LACP compliant port groups since both linked devices
must be manually configured if the configuration of the trunked group is changed. If
static link aggregation is used, be sure that both ends of the connection are
properly configured and that all ports have the same speed/duplex settings.
Restrictions Only Administrator and Operator-level users can issue this command. VDSL ports cannot be
used in a link aggregation group.
Example usage:
To create a link aggregation group:
DAS-3626:admin#create link_aggregation group_id 2
Command: create link_aggregation group_id 2
Success.
DAS-3626:admin#
155