D-Link DAS-3636, Cli Reference Manual

Page: 252 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
27
F
ORWARDING
D
ATABASE
C
OMMANDS
The layer 2 forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
create fdb <vlan_name 32> <macaddr> port <port>
create multicast_fdb <vlan_name 32> <macaddr>
config multicast_fdb <vlan_name 32> <macaddr> [add | delete] <portlist>
config fdb aging_time <sec 10-1000000>
delete fdb <vlan_name 32> <macaddr>
clear fdb [vlan <vlan_name 32> | port <port> | all]
show multicast_fdb {vlan <vlan_name 32> | mac_address <macaddr>}
show fdb {port <port> | vlan <vlan_name 32> | mac_address <macaddr> | static | aging_time}
config multicast
vlan_filtering_mode [vlanid <vidlist>|vlan <vlan_name 32>| all ] [forward_all_groups |
forward_unregistered_groups | filter_unregistered_groups]
show multicast
vlan_filtering_mode {[vlanid <vidlist>|vlan <vlan_name 32>]}
Each command is listed, in detail, in the following sections.
create fdb
Purpose Used to create a static entry to the unicast MAC address forwarding table (database).
Syntax create fdb <vlan_name 32> <macaddr> port <port>
Description This command will make an entry into the Switch’s unicast MAC address forwarding
database.
Parameters <vlan_name 32>
−
The name of the VLAN on which the MAC address resides.
<macaddr>
−
The MAC address that will be added to the forwarding table.
port <port>
−
The port number corresponding to the MAC destination address. The Switch
will always forward traffic to the specified device through this port.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To create a unicast MAC FDB entry :
DAS-3626:admin#create fdb default 00-00-00-00-01-02 port 5
Command: create fdb default 00-00-00-00-01-02 port 5
Success.
DAS-3626:admin#
247