D-Link DAS-3636, Cli Reference Manual

Page: 125 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
16
T
IME AND
SNTP C
OMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmmmyyyy > <time hh:mm:ss >
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e-day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]}]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose Used to setup SNTP service.
Syntax config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
Description This command is used to configure SNTP service from an SNTP server. SNTP must be
enabled for this command to function (See enable sntp).
Parameters
primary
−
This is the primary server from which the SNTP information will be taken.
<ipaddr>
−
The IP address of the primary server.
secondary
−
This is the secondary server the SNTP information will be taken from in the
event the primary server is unavailable.
<ipaddr>
−
The IP address for the secondary server.
poll-interval <int 30-99999>
−
This is the interval between requests for updated SNTP
information. The polling interval ranges from 30 to 99,999 seconds.
Restrictions Only Administrator and Operator-level users can issue this command. SNTP service must be
enabled for this command to function (
enable sntp ).
Example usage:
To configure SNTP settings:
DAS-3626:admin#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DAS-3626:admin#
120