D-Link DAS-3636, Cli Reference Manual

Page: 153 / 480

DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
show pvid auto_assign
Purpose Show PVID auto-assigment state.
Syntax show pvid auto_assign
Description This command is used to display PVID auto-assignment state.
Parameters None.
Restrictions None.
Example usage:
To display PVID auto-assignment state:
DAS-3626:admin#show pvid auto_assign
Command: show pvid auto_assign
PVID Auto-assignment: Enabled
DAS-3626:admin#
config gvrp timer
Purpose Used to configure the timer’s value of GVRP and MAC address of GVRP’s PDU of NNI port
in Q-in-Q mode.
Syntax config gvrp [timer [join | leave | leaveall] < value 100-100000> | nni_bpdu_addr [dot1d |
dot1ad]]
Description This command is used to set the GVRP timer’s value and GVRP’s PDU MAC address of NNI
port in Q-in-Q mode. The default value for Join time is
200 milliseconds; for Leave time is
600 milliseconds; for LeaveAll time is 10000 milliseconds. The GVRP’s PDU MAC address
can be set to which is defined in 802.1d or 802.1ad.
Parameters timer – Specifies GVRP timer will be set.
join
−
Specifies the Join time will be set
leave
−
Specifies the Leave time will be set
leaveall
−
Specifies the LeaveAll time will be set
value
−
The time value will be set. The value range is 100 to 100000 milliseconds. In addition,
the Leave time should greater than 2 Join times and the LeaveAll time should greater than
Leave time.
nni_bpdu_addr – Specifies GVRP’s PDU MAC address of NNI port in Q-in-Q mode will be
set.
dot1d – Specifies GVRP’s PDU MAC address of NNI port using 802.1d’s definement.
dot1ad – Specifies GVRP’s PDU MAC address of NNI port using 802.1ad’s definement.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To set the Join time to 200 milliseconds:
DAS-3626:admin#config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DAS-3626:admin#
148