Hardware
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
23
3.3.6 Multicon interface
The Multicon interface, CN12, is a 2x5 pin connector interface that brings the appropriate signals
for UART, SPI, I2C and external interrupts. A simple 10-pin cable can be used to route the serial
signals and power to a secondary board or another system. Pins 9 and 10 connect to an
additional connector (CN13) to provide another connection point.
Pin 24, Pin 25, Pin 26 are multiplexed pins which are connected to CN12 by default via wire
jumpers jp3, jp4 and jp5. See
Table 3-5: Serial Ports in Multicon Interface
Pin No.
Pin
Port
UART
SPI
I2C
Interrupt
CN12_1
Pin24
SCK7_1
CLK
SCL
CN12_2
Pin25
SOT7_1
TX
MOSI
SDA
CN12_3
GND
CN12_4
3V3
CN12_5
Pin21
INT13_1
INT13_1
CN12_6
Pin20
INT12_1
INT12_1
CN12_7
Pin26
SIN7_1
RX
MISO
CN12_8
Pin39
PIF
#CS
CN12_9
CN13_2
CN12_10
CN13_1
Figure 3-5: Multicon Interface
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
