Installation and Test Operation
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
12
2.3 Test Operation
The FM0+ S6E1C-Series Starter Kit has been pre-programmed with a test demo code, which
helps to test all of the on-board features. The Motorola-S format file,
tp_fm0-64l-s6e1c3.srec
, is
provided in the following directory and can be programmed on the MCU by using the FLASH
USB DIRECT Programmer.
<User_Directory>\FM0+ S6E1C-Series Starter Kit_Ver01\Firmware\Demo
Projects\Test_Demo_Code
2.3.1 Run the Test Demo
Follow the instructions to run the test code.
1. Ensure the jumpers J1 and J2 are open. Close Pin 1 and Pin 2 of J4 (default) and connect
CN3 to a PC using the USB cable provided.
Figure 2-4: Power the Board from CN3
2. If not already launched, then launch the
Serial Port Viewer
from the start menu.
3. Click the Serial Port Viewer icon in the task bar and select
FM-Link/CMSIS-DAP Cypress
FM Communications Port.
Figure 2-5: FM-Link/CMSIS-DAP Cypress FM Communications Port
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
