Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
37
4.2.3 Flash Write
4.2.3.1 Project Description
This project demonstrates the flash writing operation of the S6E1C3 device. A specific set of four
values each of four bytes in size will be written into a specific address location in the flash
memory.
4.2.3.2 Hardware Connection
No specific hardware connections are required for this project. All connections are hardwired on
the board.
4.2.3.3 Verify Output
Open the project in IAR Embedded Workbench
Power the FM0+ S6E1C-Series Starter board from CN3 using USB cable, refer
to
Open the project file in IAR Embedded Workbench from the following directory
on your PC:
IAR project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_flash\IAR
\s6e1c3_flash.eww.
Build the project and download the code into the S6E1C3 device.
Open the memory window from the
View
->
Memory
. Enter 0x00017FF0 in the
Go to
table and press the
Enter
key on your PC.
Run the program for a while (>10s).
Stop the program and check the content of 0x00017FF0 in flash.
Open the project in Keil uVision IDE.
Power the FM0+ S6E1C-Series Starter board from CN3 using USB cable, refer
to
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
