Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
35
4.2.2.2 Hardware Connection
No specific hardware connections are required for this project. All connections are hardwired on
the board.
4.2.2.3 Verify Output
Open the project in IAR Embedded Workbench
Power the FM0+ S6E1C-Series Starter board from CN3 using USB cable, refer
to
Open the project file in IAR Embedded Workbench from the following directory
on your PC:
IAR project:
<User_Directory>:
\
FM0+ S6E1C-Series Starter
Kit_Ver01
\Firmware\Demo Projects\s6e1c3_dstc\IAR
\s6e1c3_dstc.eww.
Build the project and download the code to the S6E1C3 device.
Open Watch1 window from
View
->
Watch
.
Add the arrays
m_au32SourceData
and
m_au32DestinationData
in Watch1
window.
Run the program for a while (>10s).
Stop the program and check the arrays mentioned above. The Program
Counter (PC) will stop at the routine as below which means the content of the
arrays are the same.
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
