Cypress FM0+ S6E1C-Series, Manual

Page: 6 / 55

Introduction
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C 6
1.3 Jumper and Connector
Table 1-1: Jumper Description
Jumper Function Setting
J1 Sets the programming mode pin (MD0) of
MB9AF312K (CMSIS-DAP)
Open: run mode
Closed: serial programming mode
J2 Sets the programming mode pin (MD0) of
S6E1C3
Open: run mode
Closed: serial programming mode
J3 Serial programming mode Select for
S6E1C3
Pin 2 to Pin 1: UART programming mode (not supported on this
kit)
Pin 2 to Pin 3: USB programming mode
J4 Power supply resource select Pin 2 to Pin 1: power from CMSIS-DAP (CN3)
Pin 2 to Pin 3: power from USB port of S6E1C3 (CN4)
J5 Jumper for power measurement
Open jp11 and connect a multi-meter with the terminals of J5 to
measure the current that FM0+ MCU consumes.
Table 1-2: Connector Description
Connector Description
CN1 Headphone and microphone jack
CN2 10-pin JTAG interface
CN3 USB port of CMSIS-DAP
CN4 USB port of FM0+ MCU
CN7,CN8,CN9,CN10 Arduino compatible headers
CN12,CN13 Multicon connector
1.4 Getting Started
This guide will help you get started with the FM0+S6E1C-Series Starter Kit:

The Installation and Test Operation chapter describes the installation of the kit installer,
and the test procedures for testing the board.

The Hardware chapter describes the major features of the FM0+ S6E1C-Series Starter
Kit and functionalities such as CMSIS-DAP debugger, Ethernet, USB, stereo codec,
memories and sensors.

The Software Development chapter describes how to open and run an example project
in the IAR Embedded Workbench or Keil µVision IDE; it also describes how to use the
example projects and how to program the devices using the USB DIRECT Programmer.

The Appendix provides the kit schematics, and the bill of materials (BOM).