Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
29
3. Click
Project
->
Rebuild All
to build the project.
4. Make sure the jumpers on the FM0+S6E1C-Series Starter board are placed according to the
following table:
Table 4-1: Debugging Jumper Setting
Jumper
Position
Description
J1
Open
Sets MB9AF312K (CMSIS-DAP) in run mode.
J2
Open
Sets S6E1C3 in run mode.
J4
Pin 1 to Pin 2
Power from USB port of CMSIS-DAP (CN3)
5. Connect the USB cable to CN3 port.
6. Observe that the Power LED (LED3) is glowing green.
7. Click the
Debug
icon in the tool bar; use Shortcut
Crtl+D
or choose
Project-> Download
and Debug
to start downloading and debugging.
8. Click the
Run
icon to run the program once it was downloaded successfully.
9. Click the
Stop
icon to stop the program when you want.
For more information about the IAR Embedded Workbench IDE, please click
Help
.
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
