Software Development
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
45
11. Reset the S6E1C3 by pressing the reset button (SW1) on the board, and click
OK
.
Note:
Please click on
Help
for any issues or errors encountered during programming.
4.3.2 Programming CMSIS-DAP (MB9AF312K) Using FLASH USB DIRECT Programmer
By default, the latest CMSIS-DAP firmware is programmed on the MB9AF312K already. It is not
required for the user to re-program firmware again. Follow the steps below to update the
firmware, if needed.
1. Make sure the jumpers on the FM0+ S6E1C-Series Starter board are placed according to
the below table:
Table 4-5: Programming Jumper Settings using FLASH USB DIRECT Programmer
Jumper
Position
Description
J1
Closed
Sets MB9AF312K (CMSIS-DAP) in programming mode.
J2
Open
Sets S6E1C3 in run mode.
J4
Pin 1 to Pin 2
Power from USB port of CMSIS-DAP (CN3)
2. Connect the USB cable to CN3 port.
3. Observe that Power LED (LED3) is glowing green.
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
