Hardware
FM0+ S6E1C-Series Starter Kit Guide, Doc. # 002-10542 Rev. *C
26
3.3.10 JTAG
The FM0+ S6E1C-Series Starter Kit provides an interface, CN2, to connect an external
programmer and debugger for programming and debugging the FM0+ S6E1C3 MCU. CN2 is a
standard ARM 0.05’’ 10-pin Cortex debug header.
Figure 3-9: 10-pin JTAG Interface
3.3.11 Multiplex Pins
This board has some multiplexed pins. They have connections with different peripherals or
headers using wire jumpers. User can select the connection by opening or closing the wire
jumpers on the board.
The wire jumper’s footprint is compatible with 0603 footprint. It is easy to
close them by soldering a 0R 0603 resistor on it.
shows the wire jumper information.
Table 3-6: Wire Jumpers for Multiplex Pins
Wire Jumper
Function
jp1 (default open)
Connect MCU pin45 to pin3 of CN10
jp2 (default closed)
Connect MCU pin45 to pin 26 of MB9AF312K
jp3 (default open)
Connect MCU pin24 to pin1 of Multicon interface (CN12)
jp7 (default closed)
Connect MCU pin24 to pin6 of CN7
jp4 (default open)
Connect MCU pin25 to pin2 of Multicon interface (CN12)
jp9 (default closed)
Connect MCU pin25 to pin4 of CN7
jp5 (default open)
Connect MCU pin26 to pin7 of Multicon interface (CN12)
jp8 (default closed)
Connect MCU pin26 to pin5 of CN7
jp6 (default closed)
Connect MCU pin7 to pin23 of stereo codec
jp10 (default open)
Connect MCU pin7 to pin2 of CN9
Summary of Contents for FM0+ S6E1C-Series
Page 49: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 49 Figure A 2 CMSIS DAP USB...
Page 50: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 50 Figure A 3 Stereo Codec...
Page 51: ...Appendix FM0 S6E1C Series Starter Kit Guide Doc 002 10542 Rev C 51 Figure A 4 Interfaces...
