The goal is to see the DVD player's splash
screen on your TV. To do this, select the Video
Input channel on your TV that corresponds with
the input the player is plugged into.
This procedure differs among TVs, but is
normally done by pressing the
VIDEO IN
,
INPUT
or
TV/VIDEO
button on the TV's remote
control to select the Video Input.
1
When the DVD player's splash screen appears
on your TV, you're ready to go!
2
Plug the DVD player's electrical plug into a wall
socket or power strip.
1
Press the ON / STANDBY button on the front panel,
or the STANDBY button on the remote control to
turn the DVD recorder on.
3
ON / STANDBY
Turn the POWER SWITCH on the back of the DVD
recorder ON.
2
ANGLE
GOTO
SUBTITLE
MUTE
AUDIO
DISPLAY
ON
OFF
O
I
TM
¤
There are 3 power states for this unit:
!
OFF
- The main power switch is turned off. The
unit draws no power and cannot be turned on by
the remote control.
!
STANDBY
- The main power switch has been
turned ON, but the unit has not been taken out of
standby by pressing either the STANDBY key on
the remote control or the ON / STANDBY button on
the front panel. The unit draws a slight amount of
power to enable the remote control receiving
circuit.
!
ON
- The main power switch has been turned ON,
and either the STANDBY button on the remote
control or the ON / STANDBY button on the front
panel has been pressed. The unit is ready to use.
Notes on Power States
Powering Up
Quick Start Guide
+
Plugging In and Power On
Select the Video Input on Your TV
18
When there is no activity or disc playback remains
paused for a period of about 5 minutes, the Screen
Saver will load, protecting the television from “screen
burn”, which could occur if an unusually bright image
is displayed on-screen for an extended period of time.
¤
About the Screen Saver
TM
