38
0473
90001
Rev
07.26.13
System Controls and Indicators:
Operator Control Box:
The Operator Control Box contains the status indicator lights as well as the Emergency Stop
button and the Exposure Control Switch. This can sit on a table or be mounted on a wall. It is
equipped with a 50 foot cable.
Patient Emergency Stop Button:
This Emergency stop button is intended for the patient to stop exposure during a scan. This will
seize exposure and all motors. It is located on the machine itself, by the seat, as shown below.
To Reset the button, turn it to the right so it pops out.
Patient Alignment Laser Lights:
There are 3 patient alignment laser lights on the machine. There is a horizontal and vertical in
the center of the beam, and a horizontal at the top of the beam height. The patient alignment
laser lights are controlled by a push button on the machine on the left door when open. When
the button is pushed and held down, the lights will illuminate.
Exposure Control hand held:
Hand held with coil cord for up to
10 feet away. Can be removed
from the holster.
Scan Button
for initiating the scan.
Must be held down for the duration
of the capture.
The duration of the exposure will
be indicated by an audible signal
generated by the workstation and
machine, as well as visual X-ray
ON lights
Emergency Stop Button
Press down if the exposure needs
to be stopped. This will seize
exposure, and motors.
To Reset the button, turn it to the
right so it pops out.
Status Indicator Lights:
For Power ON, Exposure Ready,
Exposure ON, Fault.
Operator
Control
Box
Summary of Contents for pedCAT
