67
Expert-32T rev.03
Expert-32T
Saving a Configuration
Saving a Configuration from the EXPERT-32T
Controller into the Configuration Module:
1- Place the configuration module on the
J10 connector, at the top left corner of
the board, with the components facing
down.
2- Simultaneously press the
MENU
SELECT
up and down-arrow keys
during a 5 seconds delay.
The following message is displayed : “ Load Configuration Press +/-
to start”.
3 - Press the up-arrow key once. The
following message is displayed: “Save
Configuration Press +/- to start”.
4- Simultaneously press the
ADJUSTMENT
up and down-arrow keys
. The configuration starts to save. Wait until it is completely
saved.
5- Once the configuration has reached 100%, press the
MENU SELECT
up and down-arrow keys
once again to exit this menu.
6- The new configuration is now saved on the configuration module.
Remove the configuration module from the connector.
Save config.
Press
Load config.
Press
Summary of Contents for Expert-32T
Page 1: ...Expert 32T Temperature Controller USER S MANUAL T...
Page 2: ......
Page 75: ......
Page 76: ...M 890 00074 rev 03 REV 01...
