Cumberland Expert-32T, User Manual, Page: 66 / 76

66
Expert-32T rev.03
USING THE CONFIGURATION MODULE
Loading a Configuration
Loading a Configuration from the Configura-
tion Module into the EXPERT-32T Controller:
1- Position the configuration module on the
J10 connector, at the top left corner of
the board, with the components facing
down.
2- Simultaneously press the MENU
SELECT up and down-arrow keys
during a 5 seconds delay.
The following message is displayed : “ Load Configuration Press +/-
to start”.
3- Simultaneously press the ADJUSTMENT up and down-arrow keys
. The configuration starts to load. Wait until it is completely
loaded.
4- Once the configuration has reached 100%, press the MENU SELECT
up and down-arrow keys once again simultaneously to exit
this menu.
5- The new configuration is now loaded. Remove the configuration
module from the connector.
Load config.
Press