Cub Crafters CARBON CUB SS CC11-160, Maintenance Manual, Page: 195 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.7
Date: 04/29/2009 Page: 17
(a) Remove the tire assembly from the fork by removing the cotter pin (1), castle nut
(23), and washer (3) then sliding the axle (21) out.
(b) At the bottom of the fork (4) remove the cotter pin (1), short castle nut (2), and
washer (3). Carefully pull the fork (11) off of the bracket (1).
(c) Separate the spacer (22), grease retainer (14), and the bearing (15) from the fork
(4).
(d) Disengage the lower dust cap (5), thrust washer (7), arm assembly (8), thrust
washer (7), pawl (6), upper dust cap (9), springs (10), thrust plate (11), and fiber
thrust plate (12) from the fork (4) and bracket (13).
(3) CLEANING
Clean all metal parts (including the bearings) in a cleaning solution. Dry all parts with
compressed air.
(4) INSPECTION
See Figure 6.3.7.4 and Figure 6.3.7.5
(a) Check the leaf springs for damage or twisting. (Figure 6.3.7.4)
(b) Replace if condition dictates.
(c) Inspect the arm assembly (8, Figure 6.3.7.5), flat spring (17, Figure 6.3.7.5), fork
(4, Figure 6.3.7.5), and bracket (13, Figure 6.3.7.5) for excessive wear, cracks or
other damage. Replace damaged parts.
(d) Examine the thrust washers (7, Figure 6.3.7.5) for wear, scoring, or other
damage. Replace if necessary.
(e) Inspect the bearing (15, Figure 6.3.7.5) and races for wear or damage. Replace
if necessary.
(5) MINOR REPAIRS
See Figure 6.3.7.5
The components that make up the tail wheel assembly may not be repaired except
that minor realignments are permitted, such as minor dents and bends.
(6) REPLACEMENT OF PARTS
Replace all cotter pins that have been removed with new cotter pins.