Cub Crafters CARBON CUB SS CC11-160, Maintenance Manual

Page: 191 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
Manual number SSC10000AMM
6.3.7
Date: 04/29/2009 Page: 13
(g) Pump the tail wheel bracket assembly and axle full of grease (MIL-G-81322E)
then wipe off the excess.
(8) INSTALLATION
See Figure 6.3.7.2
(a) Position the tail wheel springs on the fuselage with long bolt (iii) and hold in place
with a washer (ii) and a nut (i).
(b) Install the small bolts (vii), clamp (iv), and small washers (vi) with the small nuts
(v) only finger tight.
(c) Insert the bushings (x) into the tail wheel assembly, if they were removed.
(d) Insert the bolts (ix) through the bushings and tail wheel assembly.
(e) Hold in place with two washers (ii) and two large area nuts (viii).
(f) Tighten the large area nuts (viii) to 270-300 in-lbs.
(g) Tighten the nut (i) to 270-300 in-lbs.
(h) Tighten the small nuts (v) to 70-100 in-lbs.
(i) Reconnect the chain links to the tail wheel arms. The springs and chains should
neither be slack nor have tension when the wheel is centered. It may be
necessary to adjust the number of chain links to achieve this.
(j) Lower the tail section to the ground.