Cub Crafters CARBON CUB SS CC11-160, Maintenance Manual

Page: 146 / 356

CUB CRAFTERS, INC.
CC11-160 MAINTENANCE MANUAL
6.3.4
Manual number SSC10000AMM
Page: 6 Date: 09/03/2010
(k) Support the outboard end of the wing and remove the lower strut bullets. Insert
the proper bolts. Torque the nut to 95 in. lbs, torque up to the nearest
castellation, and safety with a cotter pin.
(l) Check the dihedral angle in accordance with Section B. Adjust if necessary.
(m) Check the wing washout in accordance with Section B. Adjust if necessary.
(n) Install the jury struts making sure the longer vertical tube is in front. Secure
using the appropriate bolt, washer, and nut then torque the top bolt to 38-43 in.
lbs, bottom bolt to 23-28 in. lbs.
(o) Install new aileron upper cable and install to aileron horns.
(p) Connect the flap to flap control rod. Connect the control arm to the flap handle
lever. .
(q) Route the lower aileron cable down the strut.
(r) Install the associated pulley and fairleads. Make sure the cable is not hooked on
a strut.
(s) Connect the lower aileron control cables to the torque tube link. Ensure that the
nuts have the appropriate cotter pins.
(t) Connect the pitot air tube at the wing root. Reconnect the stall warning system,
navigation, and landing light wires at the wing root.
(u) Remove the tape from the fuel line ends. Reconnect the fuel supply and gauge
lines at the wing root. Torque the ¼ inch hose clamps to 10-14 in. lbs.
Reconnect plastic fuel line fittings, torque to finger tight plus 1 ½- 2 additional
revolutions.
(v) Ensure that the aileron cables are not rubbing or hung up. Check to verify the
cable tension is 40 ± 5 lbs and, if needed, adjust in accordance with Section
6.3.6.3 Ailerons.
(w) Install the wing pulley inspection plate covers.
(x) Reinstall the front wing root, rear wing root, turtle deck, skylight, and wing/root
panel interface.