CTC Union EcoZenith i555 Pro 1x230V, Installation And Maintenance Manual

Page: 104 / 168

104 CTC EcoZenith i555 Pro
7.11.9 Calibration Sensor
Primary flow HC1 °C (B1) 0.0 (-3.0...3.0)
Correction of primary flow sensor (B1).
Primary flow HC2 °C (B2) 0.0 (-3.0...3.0)
Correction of primary flow sensor (B2).
Primary flow HC3 °C (B3) 0.0 (-3.0...3.0)
Correction of primary flow sensor (B3).
Room temperature 1 °C (B11) 0.0 (-3.0...3.0)
Correction of room sensor (B11).
Room temperature 2 °C (B12) 0.0 (-3.0...3.0)
Correction of room sensor (B12).
Room temperature 3 °C (B13) 0.0 (-3.0...3.0)
Correction of room sensor (B13).
Outdoor temperature °C (B15) 0.0 (-3.0...3.0)
Correction of outdoor sensor (B15).
Out from solar panels °C (B31) 0.0 (-3.0...3.0)
Correction of temperature sensor on solar panels for
outgoing temperature.
In to solar panels °C (B30)* 0.0 (-3.0...3.0)
Correction of temperature sensor on solar panels for
incoming temperature.
7.11.10 Set address
In this menu, heat pumps and expansion cards can be
assigned addresses.
The error message "Invalid Configuration" is displayed
if the same heat pump is specified in the "Current
address" and "New address" rows, as shown in the
menu view on the right.
Actual address (HP1...HP10, EXP1, EXP2)
Specify the current address of the heat pump or
expansion card.
New address (HP1...HP10, EXP1, EXP2)
Specify the address to be assigned to the heat pump or
expansion card.
Menu: "Installer/Service/Calibration Sensor".