18
© 2020 All rights reserved. Data subject to change without notice.
cGas Detector Analog Transmitter - Operation Manual
Rev. B | 2020.07
and caution must be exercised when removing the door to avoid damaging
the hinges. The door should only be removed when absolutely required. Any
damage occurring from door removal procedure will not be covered under
warranty.
If the unit is installed on a wall, open the enclosure fully, grasp the door,
keeping it open and being careful not to make contact with any of the internal
components (circuit board). If the base is not mounted, grasp the base with
your other hand. Tug on the door, pulling towards you making sure the door is
still open and straight.
DO NOT TWIST.
The section of the hinges located on the
base should “snap” apart from the part of the hinges located on the door.
After installation, place the door hinges over the installed base hinges, with the
unit fully open and push towards the wall. The hinges should easily “snap” back
into place.
The enclosure has one screw securing the door to the base for electrical safety
and provides an opening to allow the user to apply a padlock or tie wrap if they
desire the transmitter to be locked.
Be aware that the hinged door that could potentially pinch fingers and the sharp
edges and/or jumper pins on the board could potentially prick or cut fingers if
not handled carefully.
6.4 Mounting the Transmitter
The cGas Detector should be installed on a flat vertical surface using the four
4.4 mm / 0.175 in diameter mounting holes provided to maintain water tight
status. Care should be taken to ensure that the face of the cGas Detector is
not obstructed in order to maximize the sensor’s exposure to the environment
being monitored.
Two ½ in / 12.7 mm conduit entry points are provided in the enclosure. Both
are located in the enclosure base. One in the rear of the base and one on the