© 2020 All rights reserved. Data subject to change without notice.
17
Rev. B | 2020.07
cGas Detector Analog Transmitter - Operation Manual
6.1 General Safety Warnings
The cGas Detector is intended for indoor use, permanently mounted at a height
that is appropriate for the type of gas being monitored. Refer to Section
6.4
Mounting the Transmitter
. The cGas Detector should be protected from extreme
weather conditions.
The cGas Detector requires no assembly and virtually no maintenance other
than regular calibration of the internal and/or remote sensors and ensuring
that excess water or dust not somehow entering the enclosure and physically
damaging the circuit board or internal components. There are no serviceable
elements other than the calibration instructions outlined in this manual. There
are no replaceable components except the sensors.
6.2 Protection Against Electrical Risks
Disconnect all power before servicing. There may be multiple power sources.
Power supply may have a building installed circuit breaker / switch that is
suitably located and easy to access when servicing is required and should be
labelled as cGas Detector supply (disconnecting power to the cGas Detector).
Appropriate markings should be visible at the circuit breaker / switch that is
supplying power to the cGas Detector.
This device may interfere with pacemakers. Modern pacemakers have built-in
features to protect them from most types of interference produced by other
electrical devices you might encounter in your daily routine. If you a have a
pacemaker, follow your healthcare provider’s instructions about being around
this type of equipment.
6.3 Protection Against Mechanical Risks
The door of the enclosure can be removed if absolutely necessary to facilitate
installation of the base but it is not recommended on this version. Extreme care