Cranesmart Systems LMI System, User Manual

Page: 86 / 101

85 Cranesmart LMI Version R9
Display Panel
– Alarms
The panel has built-in audible and visual alarms. The alarm screens alternate with the primary operating screen to notify
the operator of unsafe crane conditions while continuing to provide load and positional information. The alarms are
accompanied by an audible alarm provided within the panel. The example below is a Main A2B two-block alarm. To
further help in troubleshooting there is an alarm number in the lower right hand corner of the screen. This number
coincides with the alarm that is appearing on the screen. If the alarm is too fast to read the number can be used to
identify the alarm.
When the display panel is installed and powered you may see system error screens and hear alarms. The alarms may
indicate which component (load cell, anti-2-block, angle transducer, etc) signal is not being received.
The alarms are normal until all parts of the system are installed and there is a clear line of sight to the antenna. If all the
parts of the system are correctly installed and the alarms are still sounding, check your signal strength screen (see page
83) to see if your boom mounted transmitters are sending a clear signal. You may also try moving your cab mounted
antenna for better reception.
If neither of these solutions solves the problem call our service department at (888) 562-3222 or (780) 437-2986.
NOTE:

The audible alarm is intended for the operator to hear. If you require a louder horn that can be heard across a platform or jobsite,
Cranesmart™
Systems can provide a louder horn, which automatically increases in loudness depending on the ambient noise.