Cranesmart Systems LMI System, User Manual

Page: 73 / 101

72 Cranesmart LMI Version R9
5. Use the Up or Down arrows, highlight Calibrate. Press Select.
6. Use the Up or Down arrows, highlight Level. Press Select.
7. You will be defaulted to Pitch Angle Zero. Press Select.
8. Use the Up or Down arrows to adjust the Zero Angle to zero.
9. Press Accept twice to save.
10. You will now be defaulted to the Roll Angle Zero. Press Select.
11. Use the Up or Down arrows to adjust the Zero Angle to zero.
12. Press Accept twice to save.
13. The Level transducer is now calibrated.
14. Highlight Top Menu and Press Select to continue with Supervisor permission, Back to return to the Calibrate menu or, Exit to return to
Primary Operating Screen and Operator Permission level.
Cable Reel Calibration
If your system includes a cable reel it will need to be calibrated immediately after installation.
1. Install the Cable Reel (see page 27).
2. To perform calibration you will need to access the permission codes section in the panel (see page 68).
3. Once you have entered the correct permission code, use the following steps to calibrate the cable reel.
4. Use the Up or Down arrows to highlight Top Menu. Press Select to continue with Supervisor permission. From the Top Menu use the Up or
Down arrows to select Calibrate.
5. Use the Up or Down arrows to select Cable Reel.
6. The default is Set Retracted. Fully retract your boom, then press Select.
7.
A message should be displayed, for example, “MIN BOOM CALIBRATED AT 31‟”.
8. When you have returned to the Cable Reel menu, fully extend your boom.
9. Use the Up or Down arrows to select Set Extended.
10. A message should be displayed, for exampl
e, “MAX BOOM CALIBRATED AT 70‟”.
11. Use the Up or Down arrows to select Top Menu to continue with Supervisor permission, back to return to the Calibrate Menu or, Select Exit
to return to Primary Operating Screen and Operator Permission level.