Cranesmart Systems LMI System, User Manual

Page: 60 / 101

59 Cranesmart LMI Version R9
To Disable Tare Out
If the system has a Boom Angle Indicator the Tare Out function is automatically disabled when the crane‟s angle is
changed by 3

.
To Disable the Tare Out function for a system without a Boom Angle Transducer use the following steps:
1. From the Primary Operating screen press the Select button, the Secondary Operating screen is displayed.
2. Use the Up or Down arrows select Tare.
This will automatically send you to the Primary Operating screen and you will notice that the “T” is
now gone from the end of the bar graph.
NOTE:

The amount of weight deducted with the Tare Out function will also be deducted from your load chart amount in most cases.
Setup Menus
The Setup screen displays menus to enable operators to configure settings for the system. The menus available depend
on the permission level of the user. There are two permission levels available to users:
1. Operator Permission level
– This is the basic level and can be accessed by the crane operator for simple functions
without a permission code.
2.
Supervisor Permission level
– This level requires a permission code to access functions that will affect the operation
and calibration of the system and should only be accessed by installation personnel or supervisory personnel.
To access the Setup Menus use the following steps:
1. From the Primary Operating screen, press the Select button to move to the Secondary Operating screen.
2. Use the Up or Down Arrows to move through the navigation bar, select Setup.
3. Press the Select button. You are now at the Top Menu point in the Setup Menu