Cranesmart Systems LMI System, User Manual

Page: 46 / 101

45 Cranesmart LMI Version R9
Alarm Hub
When used with the alarm hub the panel has the ability to control 4 separate outputs. These outputs can be set normally
hot or normally cold. The alarms that control the outputs of the alarm hub are specified at the time of purchase.
The standard alarm hub comes supplied with the following cables:
 4-pin Alarm output cable
 4-pin Power cable, the ends of the cable are twisted together
 2-pin Ground
 5-pin Serial cable to connect the panel to the alarm hub.
Installation of Alarm Hub
1. Locate a position to mount the alarm hub where the
operator can reach the wiring if necessary
2. Align Mark and drill holes using mounting holes on the
Alarm Hub bracket as a guide.
3. Bolt Alarm hub in place.
Wiring the Alarm Hub
1. Attach the Black wire to electrical ground
2. Attach the Red wire to power 12-24Vdc
3. Attach serial cable from alarm hub to panel.
4. Use the custom insert as a guide to wire your alarm outputs.
5. Test to see that they control the proper alarm.
NOTE:

The length of cable and the position of the panel will limit where you can mount the alarm hub.

The Plug is keyed to ensure a proper connection.