INFINITY
16
AUTOBAR
correct temperature, the machine returns to standby mode, ready to vend.
4.
To clean the brewer:
a.
Open the front door of the machine.
Dual Paperless Brewer: Using the clamp
supplied, close the tea outlet tube as shown.
Caution: Ensure that a suitable container is placed
under the dispense position. Keep hands away from the
dispense area whilst the cleaning cycle is in operation.
b.
Pour the recommended amount of destaining fluid
directly into the top of both brewer chambers.
Remove the clamp from the tea dispense pipe.
c.
Press and release the Brewer Flush button (4).
The sequence will begin and the LCD will display
the message: “Sorry Out of Service Rinsing”.
d.
Repeat step ʻcʼ until all traces of the cleaning solution have been removed from
the brewer chambers.
e.
Empty the waste water container when complete.
5.5 Button 5 - View Counters
This button enables the operator to access the Data Recall Menu. Entry into this menu allows the
operator to view Non-Resettable and Resettable Sales Data, view data relating to Timed Events
and Identification Numbers of installed components and (if feature enabled) view SureVend™
assisted vend information.
5.6 Button 6 - Test Vend
The Test Vend button (6) enables the operator to vend a drink from the machine to ensure correct
operation after cleaning or maintenance.
1.
When the button is pressed and released the LCD will display: “Test Vend, Insert
Money or Make a Selection”. Make a drink selection to begin the vend sequence.
2.
Ensure that the selection is correct, has not under/overfilled the cup and most
importantly, tastes good!
3.
Exit from the Test menu and return to stand-by mode.
5.7 Button 7 - Cup Test
This button enables the operator to test the operation of the cup drop unit after refilling the cup
stacks. When the button is pressed the cup drop solenoid is operated and a cup is ejected from
the cup drop unit. This function ensures that the mechanism is working correctly.
5.8 Button 8 - Park Head
When this button is pressed, the dispense head moves to its fully extended position and stops.
Press the button again to return the dispense head to its correct (homed) position.
5.9 Button 9 - Boiler Fill (B2C Machines Only)
When this button is pressed, the machine pumps a measured amount of water through the system
- approximately 400ml, heating it as it does so. This ensures that heated water is immediately
available when a drink is selected. This button should also be used to purge any water left in the
system after the machine has been moved or shut down for any length of time.
Se
ctio
n 5
- S
erv
ice
K
ey
pa
d F
un
ctio
ns
