Power on the devices in the following sequence:
• ADSL Router
• Computer(s)
Note!
The computer needs to be configured with the following:
• Ethernet Card supporting either;
- 10Base-T
- 100Base-TX
- 802.11b Wireless
• TCP/IP Protocol
• Web browser such as Microsoft Internet Explorer 4.0 or later.
Note!
If you are connecting via a wireless connection – the Access Point in the router is programmed with the following default parameters:
SSID - Corega
WEP - disabled
3.0 Basic Installation & Setup
This chapter describes the procedures necessary to configure the basic functions of the router to allow internet access.
The following information should be supplied by your ISP:
Provided by some ISPs
Host Name:
Domain Name:
IP address given by ISP
• Dynamic
• Static
IP address
Subnet Mask
Default Gateway
DNS Server (Primary)
DNS Server (Secondary)
WAN VPI and VCI Values
VPI
VCI
Operating Mode
• LLC Encapulation with Dynamic IP
• LLC Encapulation with Static IP
• Gateway Classical IP
• PPPoE
• PPPoA
• Router using Classical IP
PPP Authentication
Login Name
Password
Depending on your ISP, some or all of these parameters need to be programmed into the router.
Before attempting to configure the router, Corega suggest that you visit the support site of www.corega-international.com, and download a configuration file which may
help you with your particular installation. This should setup most of the parameters such that you only have to enter your username and password.
To access the router, point your web brower at:
http://192.168.1.1
Note!
For most users, a compatible IP address will be automatically allocated to each computer by the router’s internal DHCP server. If you cannot access the
router – check that the computer has been set to receive a dynamic IP address or manually configure a compatible IP address.
From Windows:
Start/Settings/Network & Dial Up Connections/Local Area Connection/Properties/TCP/IP
ENGLISH
4
