26
12. Mount the angle brackets to the upper end of all vertical sections and fix
them with the M6x12 hexagon socket screws provided (slightly tighten
by hand only).
Align the vertical section to the very left at right angle to the cross arm.
Then, push the angle bracket towards the duct roof and fix it to the
duct roof using two selftapping screws provided (drill holes ø3.3 mm
before).
Starting from the vertical section to the very left, align all other vertical
sections one after the other and fix them with the angle brackets to the
duct roof. Proceed as follows: align the corresponding section parallel
to the preceding section on the left by means of a bracket for the upper
flow sheets. Then, push the angle bracket to the duct roof and fix it using
two selftapping screws provided (drill holes ø3.3 mm before). Finally
fasten the M6x12 hexagon socket screw in the vertical section.
Important!
At the interstice with systemspecific width the bracket for
the upper flow sheet marked with a “
V
” must be used as a spacer.
Important!
The brackets for the upper flow sheets serve as spacers
only and
must not be mounted yet
(their final installation is explained
in the following section).
Starting from the (already fixed) vertical section to the very left, align
and fix the remaining vertical sections one after the other. Proceed as
follows: push the corresponding vertical section towards the duct roof
until it comes to a stop. Then, align the section parallel to the preced-
ing section on the left by means of a bracket for the upper flow sheets.
Finally, fix the screws of the respective clamping brackets.
Important!
At the interstice with systemspecific width the bracket for
the upper flow sheet marked with a “
V
” must be used as spacer.
Important!
The brackets for the upper flow sheets serve as spacers
only and
must not be mounted yet
.
12
V
V
50 mm
50 mm
50 mm
ø3.3 mm
50 mm
