Comtech EF Data Vipersat CDD-562L, Installation And Operation Manual

Page: 238 / 254

CDD-562L/564 Demodulator with IP Module Revision 2
Appendix D MN/CDD564L.IOM
D–22
D.4.1.5 Operations and Maintenance Commands and Queries
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Base Modem Boot
From BBI= 1 byte value
0,1,2 Command or Query.
The binary image, which will be used by the base modem, to boot with, where:
0 = Latest
1 = Image in Slot# 1
2 = Image in Slot#2.
Example: <1/BBI=0 BBI=
BBI! BBI? BBI=x
(see Description of Arguments)
Boot From Software
Image BLI= 1 byte, value of
0,1,2 Command or Query.
Image which will be used the next time the system is booted, where:
0 = Latest
1 = Bulk Image # 1
2 = Bulk Image # 2
Example: BLI=1 (which is Image #1 active) BLI =
BLI!
BLI? BLI =x
(see Description of Arguments)
Codecast Multicast
Address CCA= Multicast IP
Address in
xxx.xxx.xxx.xxx
format Command or Query.
Sets the Code cast multicast address, through which the modem can receive the software
updates via vLoad application. Only Multicast address in the range 224.xxx.xxx.xxx To
239.xxx.xxx.xxx are allowed. There are some reserved multicast addresses which cannot be
used.
This cannot be deleted. CCA=
CCA! CCA? CCA=xxx.xxx.xxx.xxx
(see Description of Arguments)
Load Params from
permanent storage LPS= 1-Byte value
1 – load
parameters Command only.
Set to ‘1’ to load the system with parameters from permanent storage/flash. This may force
unit reboot, depending on the mode of operation. LPS=
LPS! N/A LPS=x
(see Description of Arguments)
Param file image to
use PFI= 1 byte, value of
1 or 3 Command or Query.
Image which will be updated the next time firmware is uploaded to the system:
1 = Param1
3 = Factory Default
To restore the Factory Defaults, set PFI=3 and issue RST to reset the box. This would
bring up the box with factory default configuration.
Example: PFI =1 (using param image on flash) PFI =
PFI!
PFI? PFI =x
(see Description of Arguments)