Comtech EF Data Vipersat CDD-562L, Installation And Operation Manual

Page: 101 / 254

CDD-562L/564 Demodulator with IP Module Revision 2
Quick Start Guide MN/CDD564L.IOM
7–9
7.3.4 Set IP Address(es)
Step Task
1 From the CLI Main Menu , select Network Interface Configuration submenu [ I ] .
2 From the Interface Configuration Menu , select Ethernet Interface submenu [E] .
3 Select Ethernet IP Addresses [ I ] , then set the addresses as follows:
•
CDM-IP 1 to 172.16.10.1
•
CDD-56X to 172.16.10.2
•
CDM-IP 2 to 172.17.10.1
4 Set Ethernet Subnet MaskSubnet Prefix Length [M] to 24.
7.3.5 Set IP Stack DES Select Key to ClearRoute Table
First, perform the following steps on Satellite Modem (CDM-IP) 1:
Step Task
1 From the CLI Main Menu , select the Route Table [R] submenu.
2 Enter ‘ 1 ’ to configure the first route.
3 Enter a suitable name (e.g., ‘ test ’).
4 Set IP Address to ‘ 172.17.10.0 ’.
5 Set Number of Subnet Bits to ‘ 24 ’ .
6
For Interface to which route is destined to <E-Ethernet S-Satellite Enter : S>
select ‘ S ’ .
7
For HDLC address [SMALL NETWORK] in hex <0x1 - 0xFE, enter = 0000>:
select ‘ 2 ’ .
8 Per this example, the CDM-IP 1 Route Table should now display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001...[test 172.17.10.0/24 0x2 N/A toSat]..1
9 Go to “ Per Route ” by pressing [E] , then disable ‘HdrCompression’, ‘PayloadCompression’ and
‘3xDES’ by selecting ‘ No ’ (‘ Clear ’ for 3xDES) for each of these choices.
Next,
perform the following steps on Satellite Modem (CDM-IP) 2:
Step Task
1 From the CLI Main Menu , select the Route Table [R] submenu.