LBC-4000 L-Band Up/Down Converter System
Revision 6
Appendix B
B–2
MN-LBC-4000
Figure B-2 illustrates the cabling requirements for redundant operation. Note the following:
•
BNC connections, where applicable, use 50Ω BNC male
-to-male cables.
•
CEFD recommends that all Type ‘N’ to Type ‘SMA’ cable connections are best
accomplished using a Type ‘N’ male to Type ‘SMA’ female adapter, then using Type ‘SMA’
female-to-female cables.
Figure B-2. LBC-4000 Rear Panel – Redundancy Cabling Schematic
See Sect. B.2
for LBC-4000 Redundancy System configuration, monitor and control using the
LBC-4000 front panel.
See Sect. B.3
for LBC-4000 Redundancy System configuration, monitor and control using the
LBC-4000 HTTP (Web Server) Interface.
See Sect. B.4
for LBC-4000 Redundancy System configuration, monitor and control using the
serial remote interface.
