Computer Automation Technology CAT-800, Manual

Page: 104 / 105

16-3
Program Event Macro #29 Timed Message #1 to Play Track #3
Unlock the controller with the seven digit unlock number [1234567]. Key-up and send [*1729]
followed by a [1] to enable the macro followed by the string of internal commands to be executed. Un-
key and the voice will say: "CONTROL OK."
Timed Message #1 repeats every five minutes. To change the repeat time to once every twenty
minutes unlock the controller with the seven-digit unlock number [1234567]. Key-up and send
[*607*1200] for 1200 seconds.
NOTE: Control Zone 7 Channel 5 must be enabled for Timed Message #1 to function. This control
channel is not defaulted on. Key-up and enter [100751].
Program Event Macro #20 Port #1 Courtesy Tone as an Aircraft Cabin Chime
Unlock the controller with the seven digit unlock number [1234567]. Key-up and send [*1720 1 *
6611 3604 6610]. Un-key and the voice will say: "CONTROL OK."
Program Event Macro #33 Grandfather Clock Message to Play Westminster Chimes
Unlock the controller with the seven digit unlock number [1234567]. Key-up and send [*1733 1 *
6611 3605 6610 6311 3008 6310]. Un-key and the voice will say: "CONTROL OK."
Reprogram Voice Message #8
In voice message #8 remove the words “cat eight - hundred” and replace them with your call letters.
Example: Replace “cat eight - hundred” with “W4XYZ”
Reprogram Voice Message #8
In voice message #8 remove the words “cat eight - hundred” and replace them with your call letters.
Example: Replace “cat eight - hundred” with “W4XYZ”
Event Macro Table Position Separator
Programming Command PTT#1 and Audio Control on
Play Audio Track #3
PTT#1 and Audio Control off
*17 29 1 * 6611 3603 6610
Macro Control (1=on 0=off)
Message Number
Programming W 4 X Y Z the time is t-o-d salutation
Command
*31 08 890 004 920 930 960 830 838 482 100 103