3-12
Zone 8 Control Channels
1. Forced DTMF Entry D Key Enable (*) (All Ports)
When this channel is enabled it is possible to force a DTMF command even while the port is active. To
force a DTMF command, end the command with a [D]. This key can be changed with the [*29X]
programming command.
2. DTMF Access Enable (ALL PORTS)
When this channel is enabled, the repeater will go to sleep and not respond to normal inputs. If a
repeater user enters the DTMF Access number [325] the repeater will wake-up and continue to operate
until a period of inactivity occurs determined by the [*614*] sleep timer. Use the [*504*] programming
command to change the DTMF Access number.
3. Time of Day Request Enable (*) (All Ports)
When this channel is enabled, repeater users can request the time of day by entering the time of day
request number [400]. Example: "THE TIME IS 7:15 PM."
4. DTMF Keypad Test (*) (All Ports)
When this channel is enabled, a repeater user is able to perform a test of their radio's 12 or 16-button
keypad. Enter the keypad test number [475] followed by each of the keypad digits. As the numbers are
being decoded, they are stored in memory. When the user stops transmitting the controller will read
back all the numbers that were decoded. The Forced DTMF Entry key is defaulted to the [D] key. It
must be entered last and it will not read back during the pad test.
5. Voice Demo Request Enable (*) (All Ports)
When this channel is enabled, repeater users can play any of the twenty voice synthesizer messages.
Enter the voice demo request number [700] followed by the two-digit message number.
6. Two Tone Sequential Paging Enable (*) (All Ports)
When this channel is enabled, a repeater user can transmit a two-tone page. The first tone will be on for
one second while the second tone will be on for three seconds. Memory space is provided for twenty
paging tones. Enter the paging tone request number [650] followed by the desired two-digit paging
tone table position.
7. Digital Audio WAV Player (*) (All Ports) (Optional DR-800 Required)
When this channel is enabled, a repeater user can play digital audio tracks. Memory space is provided
for thirty tracks. Enter the digital audio WAV player request number [725] followed by the two-digit
track number. Digital audio tracks can also be integrated into voice messages, user and event macros.
8. Reserved
Summary of Contents for CAT-800
