Computer Automation Technology CAT-800, Manual

Page: 61 / 105

8-3
Define User Outputs
Click on the “Define User Outputs” tab. You will see a window similar to the one below. The CAT-800
has five user defined output switches. At default the five outputs are set up as DTMF remote control
switches. Click the down arrows to display the drop down menus. Configure the switch as a fan control
relay driver, a CTCSS encoder control switch that follows PTT or a CTCSS encoder that follows COR.
When finished click “OK”.
NOTE: The Fan Control switch will follow PTT #1 and remain on for 60 seconds after PTT #1 turns off.
The CTCSS Encoder Switch (Follows PTT) will follow PTT #1 but turn off 250mSEC before PTT #1 turns
off. The CTCSS Encoder Switch (Follows COR) will follow COR #1.
Internet Setup
Click on the “Internet Setup” tab. You will see a window similar to the one below. If you plan to
connect the CAT-800 to your router it will not be necessary to make any changes to the addresses in
this window. If you intend to connect the CAT-800 to a different Internet source you can use this
window to make changes to the new IP, Router and Port addresses. NOTE: You must cycle power on
the controller for the changes to take place.
Use this window to change the Username and Password. NOTE: Limit Username and Password to
letter and/or numbers especially the characters A to Z (lowercase or uppercase) and 0 to 9.