4-2
User Output Switches
The CAT-800 has five output switches. At default the switches are assigned as DTMF remote control
switches. They are controlled by user macros 10 through 19. From the user macro table on page 5-7,
key-up and enter [811] to turn switch #1 on or [810] to turn switch #1 off. Use the [*39XX]
programming command from the table on page 5-14 to redefine the switches to control a fan relay or
CTCSS encoder. The associated Zone 6 control channels must be enabled for the switches to operate.
Load Courtesy Tone
The CAT-800 supports eight unique courtesy tones. To manually load a courtesy tone use the [600]
prefix code followed by the port and courtesy tone number. Example: Load courtesy tone #5 into the
Port #1 courtesy tone buffer.
Port Linking User Macro Commands
The first seven User Macros have been programmed at default to connect Port #2 and or Port #3 to Port
#1. Reprogram the DTMF command, macro action and voice announcement to suite your needs. NOTE:
Port #1 has priority over Port #2 and Port #3.
USER
MACRO
DTMF
COMMAND
PORT #2
PORT #3
MACRO ACTION
01
A0
----
----
Read Port Connection Status
02
A2
ON
OFF
Connect Port #2
03
B2
OFF
OFF
Disconnect Port #2
04
A3
OFF
ON
Connect Port #3
05
B3
OFF
OFF
Disconnect Port #3
06
A23
ON
ON
Connect Port #2 and Port #3
07
B23
OFF
OFF
Disconnect Port #2 and Port #3
Event Macro
An event macro is a series of commands, defined by the repeater owner. Event macros permit the
owner to customize certain aspects of repeater operation. Event macros are assigned to various
locations through out the CAT-800 program. Examples of event macros are: logic inputs, port activity
and timed messages. The commands will execute in the order they were stored within the macro string.
The CAT-800 supports sixty event macros each containing a maximum of ten internal commands.
Voice Synthesizer Message Selection
Key-up and enter the VOICE prefix number [700] followed by the double-digit message number. The
CAT-800 will key the transmitter and play the message.
Digital Audio WAV Player Track Selection (Optional DR-800 Required)
Key-up and enter the DIGITAL AUDIO WAV PLAYER TRACK prefix number [725] followed by the double-
digit track number. The CAT-800 will key the transmitter and play the track.
Programming Command Courtesy Tone Number (1-8)
600 1 5
Port # (1-3)
Summary of Contents for CAT-800
