Infortrend
5-29
Its current status will be displayed on
the LCD. Press
ENT
to continue.
Press
ENT
again for two seconds to
change the terminator mode to the
alternate setting.
IMPORTANT!
•
You can use terminator jumpers on the controller board to control SCSI
bus termination of the SentinelRAID series controllers. When using
jumpers to control, firmware termination setting must be disabled. To
disable SCSI termination of a SCSI bus, the associated terminator jumpers
must be left open, and firmware setting must be disabled.
Setting Transfer Speed
Transfer speed refers to the SCSI bus speed in synchronous mode.
Asynchronous mode is also available in this option setting. In
Ultra/Ultra Wide SCSI, the maximum synchronous speed is
20.8Mhz.
Press
ENT
for two seconds to enter the
Main Menu. Press
▼
or
▲
to select
"View and Edit SCSI Channels," then
press
ENT
.
Channel information will be displayed.
Press
▼
or
▲
to select a channel. Press
ENT
on the channel you wish the
transfer speed changed.
Press
▼
or
▲
to select “Set Transfer
Speed," then press
ENT
.
The current speed of this SCSI channel
will be displayed. Press
▼
or
▲
to
select the desired speed, then press
ENT
for two seconds to confirm.
IMPORTANT!
•
Every time you change the Transfer Speed, you must reset the controller
for the changes to take effect.
View and Edit
SCSI Channels
↕
CH0=Host PID=0
SID=NA SXF=80.0M
Set Transfer
Speed ..
SCSI Terminator
Enabled ..
CHL=0 Clk=80.0M
Change to=40.0M?
CHL=0 Disable
Terminator ?
