156
Changing network configuration
To reset the IP address or change the network configuration of the
Primary Network Interface:
1.
On the LCD console, hold down the
button for
approximately 2 seconds.
The LCD screen displays:
SELECT:
SETUP NETWORK
2.
Press the
button.
3.
Enter the IP address of the Primary Network Interface using the
arrow buttons. The left and right arrow buttons move the cursor
position to the left or right. The up and down arrow buttons increase
or decrease the digit at the cursor position.
4.
Press the
button.
5.
Enter the Netmask of the Primary Network Interface using the
arrow buttons.
6.
Press the
button.
7.
Enter the Gateway using the arrow buttons
8.
Press the
button.
9.
Use the arrow buttons to toggle the cursor between [S]ave or
[C]ancel.
10. Press the
button.
If you select the
Save
option, the Qube 2 reboots using the new network
configuration. If you select
Cancel
, you return to step 1 of this
procedure.
You can also change the network configuration of the Qube 2 through
the Web browser:
1.
On the
Administration Site
screen, click
Network
on the left. Edit
the network settings in the tables.
2.
Click
Save Changes
.
If you change the network IP address of the Qube 2 through the Web
browser, the Qube 2 reboots automatically when you click
Save
Changes
.
Select
Enter
Enter
Enter
Enter
Enter
Summary of Contents for Cobalt Qube 2
