![Club Car FE 350 Maintenance And Service Supplement Download Page 79](http://html1.mh-extra.com/html/club-car/fe-350/fe-350_maintenance-and-service-supplement_2626732079.webp)
TROUBLESHOOTING AND ELECTRICAL SYSTEM
Test Procedures
11
TEST PROCEDURE 17 – Kill Limit Switch
See General Warning on page 10-1.
The kill limit switch is located inside the electrical component box. The accelerator kill switch is the lower of the two
limit switches and has a white/black wire and black wire connected to it.
1.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery – Gasoline Vehicles, Section 10,
2.
Check for proper wiring and tight connections.
3.
Disconnect the wires from the limit switch and test the limit switch for continuity.
–
For pedal-start vehicles:
Place the red (+) probe of the multimeter on the common (COM) terminal
(white/black wire) of the limit switch. Place the black (–) probe on the normally open (NO) terminal (black wire)
of the limit switch. Without the lever pressed, the reading should be no continuity. Press the lever, and the
reading should be continuity. If either reading is incorrect, replace the limit switch
–
For key-start vehicles:
Place the red (+) probe of the multimeter on the common (COM) terminal (orange
wire) of the limit switch. Place the black (–) probe on the normally open (NO) terminal (brown wire) of the limit
switch. Without the lever pressed, the reading should be no continuity. Press the lever, and the reading should
be continuity. If either reading is incorrect, replace the limit switch
4.
Connect wires to limit switch and check for tight connections.
5.
Connect battery and spark plug wire(s).
See Connecting the Battery – Gasoline Vehicles, Section 10, Page
NO
COM
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
1
2
1. 200 Ohm Setting 2. Lever Up
NO
COM NC
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK
5XL
V
V
V
A
!
!
COM
200nA
MAX
1000 ---
750V
FUSED
1
2
1. 200 Ohm Setting 2. Lever Up
476
Figure 11-38
Kill Limit Switch Test for Pedal-Start Vehicle
Figure 11-39
Kill Limit Switch Test for Key-Start Vehicle
2009 FE 350 Maintenance and Service Supplement
Page 11-37