Club Car FE 350, Maintenance And Service Supplement

Page: 250 / 280

18
Unitized Transaxle Installation UNITIZED TRANSAXLE
Club Car
587
Figure 18-38 Driven Clutch and Key
588
Figure 18-39 Snubber and Bracket
14. Position the floor jack under the rear frame crossmember and raise the jack high enough to support the vehicle
(Figure 18-40, Page 18-16) . Make sure the vehicle is stable on the jack, then remove the jack stands.
15. After the jack stands are removed, lower the vehicle to approximately its normal height. Position the leaf springs
in the front spring mounts and install the bolts and lock nuts. Tighten to 15 ft-lb (20.3 N·m).
16. Adjust the vehicle height with the floor jack to position the leaf springs for mounting in the shackles. Install the
mounting bolts, and lock nuts (Figure 18-41, Page 18-16) .
ClubCar
ClubCar
ClubCar
ClubCar
844
Figure 18-40 Leaf Springs
845
Figure 18-41 Leaf Springs and Shackles
17. Position shocks in the shock mounts and install cushions, mounting washers and nuts (Figure 18-42, Page
18-17) . Tighten nuts until cushions expand to be the same diameter as the mounting washers.
18. Connect brake cables. See Brakes section in the appropriate Maintenance and Service Manual.
19. Connect the engine kill switch wire (18-gauge white/black) to the bullet connector at the lower right front of
the engine (Figure 18-43, Page 18-17) .
Page 18-16 2009 FE 350 Maintenance and Service Supplement