Club Car FE 350, Maintenance And Service Supplement

Page: 119 / 280

ELECTRICAL COMPONENTS Kill Limit Switch
12
KILL LIMIT SWITCH
See General Warning on page 10-1.
TESTING THE KILL LIMIT SWITCH
See Test Procedure 17 – Kill Limit Switch on page 11-37.
KILL LIMIT SWITCH REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section 10,
Page 10-2.
2. Remove electrical component box cover (1) (Figure 12-19, Page 12-19) .
3. Pedal-Start vehicle: Remove the two nuts (9) and washers (10) securing the accelerator pedal limit switch (11).
Do not disconnect the wires attached to switch (11) (Figure 12-19, Page 12-19) .
4. Disconnect the two white/black wires and the black wire from the kill limit switch (12).
5. Remove the kill limit switch (12).
15
9
10
12
13
8
1
A
20
16
21
11
A. To Voltage Regulator
517
Figure 12-19 Accelerator Starter and Kill Limit Switches
KILL LIMIT SWITCH INSTALLATION
1. Install the kill limit switch (12) onto the two screws (16) (Figure 12-19, Page 12-19) .
2. Connect the two white/black wires to the common (COM) terminal and the black wire to the normally open (NO)
terminal of the kill limit switch (12) and place the switch on the mounting screws located in the electrical component
box. Place the accelerator limit switch (11) on the mounting screws located in the electrical component box.
3. Secure the switches using two washers (10) and two nuts (9). Tighten to 5 in-lb (0.6 N·m). See following
CAUTION.
2009 FE 350 Maintenance and Service Supplement Page 12-19