Club Car FE 350, Maintenance And Service Supplement

Page: 195 / 280

S10 FE350 FUEL SYSTEM Fuel Pump
15
2. Remove four screws (24) and lock washers (25) from front of the fuel pump (Figure 15-16, Page 15-23) .
3. Remove the front cover (37) of the fuel pump while holding the rest of the pump intact.
4. Note the orientations of the impulse gasket (27), the diaphragm (28), and the gasket (29), then remove them
from the pump.
5. If the impulse gasket (27) and the diaphragm (28) come off with the front cover, note their orientations and
remove them.
6. Remove the pumping chamber (30).
7. Remove the back cover (36), the fuel diaphragm (34), and gasket (35).
FUEL PUMP CLEANING AND INSPECTION
1. Using a nonflammable solvent, clean the front cover, pumping chamber, and back cover. Be sure the vent
(40) on the front cover is clean both inside and out.
2. Inspect the valve assemblies (31, 32, and 33) and all gaskets and diaphragms for damage (Figure 15-16,
Page 15-23) .
3. If a valve assembly is damaged, the rubber retaining plug (33) and valve assembly must be replaced.
24
32
31
30
35
38
34
36
33
39 40
25
37
27
28
29
1
2
3
4
5
1. Fuel Outlet 2. Vent 3. Fuel Inlet 4. Impulse Line 5. Direction of
Fuel Flow
547
Figure 15-16 Fuel Pump
548
Figure 15-17 Fuel Pump Orientation
FUEL PUMP ASSEMBLY
1. Install the fuel gasket (35) and diaphragm (34) on the back cover (36) (Figure 15-16, Page 15-23) .
2. Install the valve assembly in the pumping chamber (30). See following CAUTION.
2009 FE 350 Maintenance and Service Supplement Page 15-23