Club Car FE 350, Maintenance And Service Supplement

Page: 181 / 280

S10 FE350 FUEL SYSTEM Engine Control Linkage
15
Governor Cable Installation and Adjustment
1. Install the cable onto the governor cable support bracket (10) and the engine bracket (11) (Figure 15-9, Page
15-9) .
2. Push the cable dust shields onto the ends of the cable conduit.
3. Connect the governor cable to the carburetor throttle at the carburetor.
4. Connect the governor cable to the governor lever arm (15) (Figure 15-9, Page 15-9) .
5. With the governor lever arm loose on the governor shaft, use a 1/8-inch punch or scratch awl to turn the governor
arm shaft counterclockwise until it stops. Then pull the governor lever arm rearward until the carburetor throttle is
in the “wide open throttle” (WOT) position.
6. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut to
36 in-lb (4.0 N·m).
7. Check engine RPM adjustment. See Engine RPM Adjustment on page 15-11.
6
14
12
10
15
17
13
11
1
2
2
6
16
5
3
4
542
Figure 15-9 Governor and Accelerator Cables
2009 FE 350 Maintenance and Service Supplement Page 15-9