Club Car FE 350, Maintenance And Service Supplement

Page: 225 / 280

S27 FE 350 FUEL SYSTEM Fuel Pump
16
24
32
31
30
35
38
34
36
33
39 40
25
37
27
28
29
1
2
3
4
5
1. Fuel Outlet 2. Vent 3. Fuel Inlet 4. Impulse Line 5. Direction of
Fuel Flow
547
Figure 16-16 Fuel Pump
548
Figure 16-17 Fuel Pump Orientation
FUEL PUMP ASSEMBLY
1. Install the fuel gasket (35) and diaphragm (34) on the back cover (36) (Figure 16-16, Page 16-23) .
2. Install the valve assembly in the pumping chamber (30). See following CAUTION.
CAUTION
• If the valve assembly is not installed exactly as shown (Figure 16-16, Page 16-23), the impulse fuel
pump will not operate properly.
3. Install the pumping chamber (30) on top of the fuel diaphragm (34). Be sure the fuel inlet (38) and the fuel outlet
(39) align with the arrows on the front of the front cover.
4. Install the gasket (29), clear impulse diaphragm (28), and the paper impulse gasket (27) to the pumping chamber
(30).
5. Install the front cover (37) and then the lock washers (25) and four screws (24) on the assembly. Be sure
the arrows on the front cover point from the fuel inlet to the fuel outlet
(Figure 16-17, Page 16-23) . Tighten
the screws to 26 in-lb (3.0 N·m).
FUEL PUMP INSTALLATION
1. Connect to the fuel pump the fuel line (2) that comes from the fuel filter (17). Install a new clamp (16). Route the
fuel lines as shown
(Figure 16-14, Page 16-19 and Figure 16-15, Page 16-20) .
NOTE: Be sure to connect the fuel line (2), that comes from the fuel filter (17), to the inlet nipple on the pump.
Direction of fuel flow is indicated by the arrows on the fuel pump (Figure 16-14, Page 16-19 and Figure
16-15, Page 16-20) . See also (Figure 16-17, Page 16-23).
2009 FE 350 Maintenance and Service Supplement Page 16-23