Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 61 / 132

P/N 102615, Rev. 0 Page 43
rental or sale of this machine, read and
throughly understand the operating instruc-
tions for the HPU being used.
2. On the pneumatically powered machine, com-
plete these steps on the Air Caddy (shown in
Figure 4-6):
a) Open the
AIR SUPPLY LOCK
-
OUT
valve.
b) Pull up the
EMERGENCY STOP
button.
c) Press the
START
button.
d) Slowly open the
SPEED ADJUSTMENT
valve
until the rotary speed reaches the desired
rate.
3. Engage the number of feed trippers required for
the finish type (see Section 3.4.7 on page 37).
F
IGURE
4-7. F
EED ADJUSTMENT SCREW AND FEED DIRECTION KNOB
4. To adjust the feed rate: Stop the machine (see
Section 4.3.2 on page 43), then fine-tune the
feed adjustment screw setting based on the ini-
tial cut rate.
5. Adjust the feed rate and rotary speed as neces-
sary to maintain the desired cut.
6. On a pneumatic motor drive machine, adjust
the oil drip rate as needed (see Figure 4-6).
NOTICE
For best machine performance and service life, H&S
recommends a minimum Air Caddy oil drip rate of
six drips per minute.
4.3.2 Stopping the machine
Do the following to stop the ODF Speed Facer:
1. Disengage the feed trippers (see Figure 3-12 on
page 37).
2. On a pneumatic motor drive machine:
a) Turn the
SPEED ADJUSTMENT
valve clockwise
to close it.
b) Press the
AIR SUPPLY LOCK
-
OUT
valve down to
close it (seen in Figure 4-6). This will
release residual air pressure in the Air
Caddy circuit.
3. On a hydraulic motor drive machine, reference
the included HPU (hydraulic power unit) operat-
ing instructions for powering down and locking
out the unit. If the HPU is not being supplied as
part of the rental or sale of this machine, read
and throughly understand the operating instruc-
tions for the HPU being used.
4.3.3 Adjusting the machine settings
Do the following to manually adjust the cutting tool
position or angle:
1. Disengage the feed trippers (see Figure 4-7).
2. Stop and lock out the machine (see
Section 4.3.2).
3. Manually adjust the cutting tool position or
angle (see Section 3.4.3 on page 34 and Section
3.4.4 on page 35).
WARNING
Do not attempt to manually adjust the cutting tool
angle or change the feed box settings during
operation. Attempting to operate the feed box
controls by hand or with hand tools while the
machine is running may result in severe injury.