Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 65 / 132

P/N 102615, Rev. 0 Page 47
3. Press the
START
button.
4. Slowly open the Air Caddy speed adjustment
valve until the rotary drive engages.
5. Close (by pressing down) the Air Supply Lock-
out valve.
6. Check that the ODF Speed Facer stops.
7. Open the
AIR SUPPLY LOCK
-
OUT
valve.
8. Check that the machine does not start.
5.3.3 Testing the emergency stop
Do the following to test the emergency stop:
1. With the machine running, press the
EMERGENCY
STOP
button.
2. Check that the machine stops.
3. Reset the
EMERGENCY STOP
by pulling the button
up.
4. Check that the machine does not re-start.
5.3.4 Dovetail ways
5.3.4.1 Radial dovetail ways
Do the following to perform maintenance on the radial
dovetail ways:
1. On the slide assembly, use the radial feed screw
to move the tool head to one end of the radial
feed track.
2. Wipe down the exposed dovetail ways and lubri-
cate them with Mobil VACTRA medium heavy
way oil or equivalent.
3. Move the tool head assembly to the other end of
the radial feed track.
4. Wipe down the remaining exposed dovetail
ways and lubricate them with Mobil VACTRA
medium heavy way oil or equivalent.
5.3.4.2 Axial dovetail ways
Do the following to perform maintenance on the axial
dovetail ways:
1. On the slide assembly, use the axial feed screw
to move the tool slide to one end of the axial
feed track.
2. Wipe down the exposed dovetail ways and lubri-
cate them with Mobil VACTRA medium heavy
way oil or equivalent.
3. Move the tool slide to the other end of the axial
feed track.
4. Wipe down the remaining exposed dovetail
ways and lubricate them with Mobil VACTRA
medium heavy way oil or equivalent.
5.3.5 Lubricating the roller bearing
Do the following to lubricate the roller bearings during
use (every four hours):
1. Attach the grease gun nozzle to the grease fit-
ting on the side of the machine.
2. Start the machine and bring it to normal operat-
ing speed.
3. Apply approximately 1/4 oz or 6 squeezes from
a 14 oz grease gun of ThermaPlex LPS bearing
grease.
4. Allow the machine to continue to rotate several
times to evenly distribute the grease.
5. Stop the machine and remove the grease gun.
NOTICE
The rollers should be lubricated once for every 4
hours of use.
F
IGURE
5-1. G
REASE FITTING
5.3.6 Belt adjustment and replacement
The belts should be clean, dry, and properly tensioned.
Belts that are broken, frayed, or otherwise damaged
must be replaced.
NOTICE
Always order and replace both belts together.
Do the following to check belt tension:
1. Remove the two 1/4 NPT pipe plugs from the
side of the frame (near the grease fitting shown
in Figure 5-1).